Configures the number of receive descriptors for jumbo frames larger than bytes. All primary NIC interfaces in a team will participate in Load-balancing operations by sending and receiving a portion of the total traffic. When jumbo frames larger than bytes are used, this parameter should not be set lower than 60 on systems with high network traffic. On systems with insufficient memory, it may be necessary to reduce this parameter. When the maximum frame size is less than MTU size less than , this parameter is not used and is always 0.
||24 February 2008
||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
||Free* [*Free Regsitration Required]
Three packages are shipped in this release: Note that the MTU size excludes the ethernet header size of 14 bytes.
To rectify the situation, locate the rpm-build package on the Red Hat installation media and install it using ethernnet command: Note etherneet each descriptor will also require a buffer the size of a maximum jumbo frame.
Removal of Physical Interface in Generic Trunking and In the case of supporting only the module version of these drivers, it is possible to simply run the following to compile patched drivers and to install them into the proper module directory:.
Broadcom BCM LAN card drivers on FTP
Configures the number of transmitted frames before the NIC generates transmit interrupt. The most recent Red Hat distributions are included. When this happens, repeat Step 2 to configure an IP address for all the virtual network interfaces. Default is and valid range is bcm5075 1 to The Linux driver is released in three packaging formats: Set to 0 to disable statistics updates.
The PCI ID Repository
Enables or disables receiving flow control pause frames. Configures the number of received frames before the NIC generates receive interrupt.
Most systems are set to level 6 by default. The tar file contains additional utilities such as patches and driver diskette images for network installation.
This mode is protocol-independent and all traffic should be load-balanced and fault-tolerant. Boot drivers for other Linux versions can conroller compiled by modifying the Makefile and the make environment. Note that the –force option is needed if installing on some distributions that may already contain an older version of the driver.
In the case that this first physical interface is removed dynamically from the team using “baspcfg” tool and bounded to the protocol directly, this could lead to a duplicate MAC address problem on the network. When the maximum frame size is less than MTU size less thanthis parameter is not used and is always 0.
This tool can be used in custom initialization scripts. Configures the number of transmit descriptors. These features are netxtrdme by creating teams that consist of multiple NIC interfaces.
Note that if the removed physical interface does not participate in any traffic, there will not be any problem.
This mode is protocol-independent and all traffic will be load-balanced and fault-tolerant. Patching Driver Into Kernel. Please read all restrictions and disclaimers.
On systems with insufficient memory, it may be necessary to reduce this parameter. After extraction, change the directory to where the BASP source files are located.
This section contains the following information: The valid range for this parameter is to Configures the number of receive descriptors for frames up to bytes. All the physical interfaces in the Both packages include the exact same script and MIB files.